We built the 290mm Halogen Lamp for engineers who need a heat source that’s small, fierce, and tough enough for the factory floor. This isn’t your everyday bulb. It’s a focused infrared heater, built to give you repeatable heat where space is tight and timing is everything. Here’s the thing about that 290mm length: it wasn’t an accident. It gives you a predictable heat pattern without eating up extra room in your equipment. Pair that with high-wattage halogen capsules, and you get serious power packed into a compact space. The high-voltage setup is made for industrial control systems, so it stays steady even when the load changes. The payoff? Fast ramp-up and a temperature that holds steady, exactly what you need for processes that run on a tight clock. Inside, a quartz envelope protects a halogen filament cycle. The halogen chemistry does a neat trick—it redeposits evaporated tungsten back onto the filament. That keeps the quartz clean, extends the lamp’s life, and stops output from fading over time. And the R7s connector? It’s a simple, two-pin design that makes the lamp a straight swap for standard fixtures. Wire it up, lock it in, and get back to work. Use this lamp when you need heat, fast, and right where you need it—like sealing plastic, drying components, or curing finishes. The 290mm size gives you a tight heat footprint, and the infrared output cuts straight in for quicker cycles. Just keep in mind, that high power density means you need proper machine cooling and shielding. Set up the heat sinking and guarding up front, and you get a heater you can count on, shift after shift.