Introduction
Here’s the thing—if you’re hunting for an industrial infrared halogen lamp that just drops right into your existing setup, we’ve got you covered. We built these to be straightforward replacements for process heating jobs. They come in 1000W and 2000W, in a 354mm tube length, with a half-white reflector and an R7s base. If you need a heat tube that slides into the fixtures you already have, this is exactly what you’re looking for. No fuss, no re-engineering—just a clean swap.
Power, Voltage, and Dimensions
The wattage gives you a simple way to match the heat to the work. Go with the 1000W when you want a steadier, lower peak. Need to warm up faster and keep the line moving? The 2000W steps up the heat density so you can hit temperature quicker and run more throughput. And that 354mm length? It’s chosen to fit standard reflector assemblies. So you don’t have to rework the machine footprint. It just fits.
Material and Design
Inside, the halogen cycle keeps the filament stable even when it’s running hot. That’s what helps the output stay consistent over the life of the lamp. The half-white reflector is all about focus. It throws infrared where you need it, with less glare. More energy lands on the target, where it should. Then there’s the R7s bi-pin base—an industrial standard for a reason. It locks in quickly and securely. You wire it once, and it stays put. No wiggle, no worry.
Application and Benefits
These lamps were born to replace aging or burnt-out halogen heat tubes. You get infrared output you can count on, response that’s fast, and an install that’s basically plug-and-play. Swap it in and get back to work. Just keep one thing in mind: higher wattage means more heat per unit length. So make sure your machine’s cooling and guarding are set up to handle the temperature around the tube. Plan for it, and you’re good.